Skip to main content

1.1

Major VersionM

by Pete Prodoehl

Introduction

A 3D Printed LEGO Compatible mount for a Thumbstick Sensor.

Tools

Parts

No parts specified.

  1. You can download the file and print it on your own 3D Printer.
  2. The Thumbstick Sensor slides into the holder and is held in place by friction. If the fit is a bit too tight you can file or sand the inside holding arms of the print.
    • The Thumbstick Sensor slides into the holder and is held in place by friction. If the fit is a bit too tight you can file or sand the inside holding arms of the print.

    • Every 3D printer is a little different! If your part doesn't fit on a baseplate here are a few things to try.

    • Part too tight? Try sanding it or cutting away some material with a knife.

    • Part too loose? Add two LEGO bricks on opposite sides of the part.

    • You can also try printing it at slightly more or less than 100% scale.

Finish Line

One other person completed this guide.

Pete Prodoehl

Member since: 03/04/2020

281 Reputation

159 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 78