Skip to main content

1.01

Minor Versionm

by Joshua

Introduction

The Solar Bug has been updated! Now the solar cell is connected to the motor via the included conductive tape. Please use the PDF directions for the new version.

Parts

Video Overview

Featured Document

  1. Use acrylic paint (standard) to paint the top to your bug.
    • Use acrylic paint (standard) to paint the top to your bug.

    • Let dry.

  2. From the top of your bug, push the motor through hole.
    • From the top of your bug, push the motor through hole.

    • Once through, put a rubber o-ring over the motor and move it up next to the wood.

    • This will hold your motor in place.

  3. Peel off the protective backing from the tape. Stick to the back of the solar cell.
    • Peel off the protective backing from the tape.

    • Stick to the back of the solar cell.

    • Peel off the other protective layer from the tape.

    • Stick to bug body.

  4. Cut each pipe cleaner in half.
    • Cut each pipe cleaner in half.

    • Each pipe cleaner goes through two holes.

    • Insert pipe cleaners as shown in the diagram.

Finish Line

Attached Documents

Joshua

Member since: 11/16/2017

4,339 Reputation

65 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 12

Past 30 Days: 37

All Time: 861