Skip to main content

1.03

Minor Versionm

by Joshua

Introduction

We often have piles of CR2032 coin cell batteries around, and it's always a pain to figure out which ones are good or not. Thats why we've made this simple coin cell battery holder tester using a red LED, some Maker Tape, and a clothespin.

Video Overview

  1. The long leg of your LED is the positive leg. Bend it in half and then outward.
    • The long leg of your LED is the positive leg.

    • Bend it in half and then outward.

    • Bend the short leg outward. Don't bend it in half. (It doesn't matter if you do or not.)

  2. Open up your clothespin and apply tape on the flat inside area. Go around the lip. Cover the bent, positive leg, of your LED.
    • Open up your clothespin and apply tape on the flat inside area.

    • Go around the lip.

    • Cover the bent, positive leg, of your LED.

  3. Cover the negative leg of your LED with tape. Go around the backside of the clothespin and to the bottom. End on the other flat inside area.
    • Cover the negative leg of your LED with tape.

    • Go around the backside of the clothespin and to the bottom.

    • End on the other flat inside area.

    • Don't overcomplicate things on the back, inside V area. The part where you press together. We like to go inside a bit with some tape to make it look clean, but as long as it works when you're finished... who cares?

  4. Put a battery in and see if it works.
    • Put a battery in and see if it works.

    • If it DOESN'T work flip the battery over and try again. You may have gotten your LED legs backwards.

Finish Line

One other person completed this guide.

Joshua

Member since: 11/16/2017

8,249 Reputation

129 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 27

All Time: 342