Create your own light up Laser Shark using an LED and a straw! This light up Laser Shark card only takes minutes to make and is activated by a paper switch.
We bought these clear straws from Amazon. You can also use colored straws, but if you do that be sure to only use white LEDs so they'll shine through the straw better.
Most 5mm LEDs should fit into the straw just fine, though if you want the LED to go in all the way you'll need to cut a small slit in the end of the straw. (You don't need to do this, but it may be helpful if you're using colored straws.)
We used a thin line of hot glue to hold down the straw. We recommend slightly rolling the straw once it's down to help spread out the glue. When using a clear straw the glue reflects the light and gives it a fun look.
In general build this project in this order: Color or decorate your card, poke LED legs through the paper, add tape and battery, add the straw.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.