Skip to main content

1.01

Minor Versionm

by Joshua

Introduction

Why mess with a regular pumpkin when you can create your own custom light up Jack-O-Lantern using conductive tape and paper!

Tools

Parts

Video Overview

Featured Document

  1. Print off the template, trace it, and cut out your pumpkin parts.
    • Print off the template, trace it, and cut out your pumpkin parts.

    • If you plan on freehand cutting your body, be sure to read all the directions first. Pay special attention to how we create the battery holder.

  2. The long leg of an LED is Positive, and the short leg is Negative. For this project the Positive legs go on the bottom, and the Negative legs go on the top. Bend both LED legs 90 degrees. Stick the long Positive legs through the paper. It may help to cut a small slit in the paper.
    • The long leg of an LED is Positive, and the short leg is Negative. For this project the Positive legs go on the bottom, and the Negative legs go on the top.

    • Bend both LED legs 90 degrees.

    • Stick the long Positive legs through the paper. It may help to cut a small slit in the paper.

  3. Run two pieces of tape along the top of your project.
    • Run two pieces of tape along the top of your project.

    • Stop right next to the ball at the end.

    • The two top pieces can touch, though the should NOT touch the tape from the backside.

  4. Run lines of tape from the Positive LED legs back round to the front. Do not connect the Positive and Negative tape lines.
    • Run lines of tape from the Positive LED legs back round to the front.

    • Do not connect the Positive and Negative tape lines.

  5. Position your LED legs over each of the lines of tape. Use a small piece of Conductive Tape to tape down each of the legs. Do this to all 4 LED legs.
    • Position your LED legs over each of the lines of tape.

    • Use a small piece of Conductive Tape to tape down each of the legs.

    • Do this to all 4 LED legs.

  6. Place a battery so that bottom (Negative) side is over the two Negative lines of tape.  (Top side) Fold down the bulb on the back so that the two Positive lines of tape make contact with the top of the battery.
    • Place a battery so that bottom (Negative) side is over the two Negative lines of tape. (Top side)

    • Fold down the bulb on the back so that the two Positive lines of tape make contact with the top of the battery.

    • Both LEDs should turn on.

    • When in doubt, flip the battery over and try again. This solves 90% of all building errors.

  7. Use a binder clip or paper clip to hold the battery holder together.
    • Use a binder clip or paper clip to hold the battery holder together.

    • To "Turn Off" the project, just remove the clip.

  8. Attach the other cut outs to your pumpkin body. Attach the other cut outs to your pumpkin body.
    • Attach the other cut outs to your pumpkin body.

Finish Line

Attached Documents

Joshua

Member since: 11/16/2017

48 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 197