Skip to main content

1.2

Major VersionM

by Pete Prodoehl

Introduction

Create a fun light-up card for Valentine's Day. Just add two LEDs, a CR2032 battery, and some Maker Tape.

Tools

Parts

Video Overview

Featured Document

  1. In general build this project in this order: Print out the full-color card, or print out the black and white card, and color/decorate as desired.
    • In general build this project in this order:

    • Print out the full-color card, or print out the black and white card, and color/decorate as desired.

    • Poke holes through front for LED legs, then push legs through front.

    • On inside of card, bend legs down flat against paper.

    • Add Maker Tape and battery to complete your circuit.

    • Note: If you are using thicker paper (such as cardstock) we recommend using a large safety pin to poke the holes in the paper to put the LED legs through.

Conclusion

Enjoy your card!

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

131 Reputation

138 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 13

All Time: 152