Skip to main content

1.0

Major VersionM

by Joshua

Introduction

This paper craft flower is a simple way to jazz up any fancy occasion. Follow the download the guide, watch the video, or follow the directions below.

Tools

Parts

Video Overview

Featured Document

  1. Print off the template, trace it, and cut out your flower. If you plan on freehand cutting your body, be sure to read all the directions first. Pay special attention to how we create the battery holder. If you plan on freehand cutting your body, be sure to read all the directions first. Pay special attention to how we create the battery holder.
    • Print off the template, trace it, and cut out your flower.

    • If you plan on freehand cutting your body, be sure to read all the directions first. Pay special attention to how we create the battery holder.

  2. Use two lines of conductive tape, one on each side. Wrap one line of tape around the short leg of the stem.
    • Use two lines of conductive tape, one on each side.

    • Wrap one line of tape around the short leg of the stem.

  3. Line up your layers of flower peddles and cut a slit in the middle of each one. Poke both LED legs through the slits. You want to leave enough room so that you can spread both legs apart a bit.
    • Line up your layers of flower peddles and cut a slit in the middle of each one.

    • Poke both LED legs through the slits.

    • You want to leave enough room so that you can spread both legs apart a bit.

  4. Place one leg on each side of your stem, over the top of the tape. One leg per piece of tape. Cut off a small piece of tape and use it to tape down each of the LED legs to the conductive tape on the stem.
    • Place one leg on each side of your stem, over the top of the tape. One leg per piece of tape.

    • Cut off a small piece of tape and use it to tape down each of the LED legs to the conductive tape on the stem.

  5. Place your battery at the bottom of the stem. Folder over the short end of the stem.
    • Place your battery at the bottom of the stem.

    • Folder over the short end of the stem.

    • Your LED should light up. If it does not, flip the battery over and see if that fixes things.

  6. Use a paperclip or binder clip to hold the battery flap in place. Add in your leaves by using glue, tape, or other means.
    • Use a paperclip or binder clip to hold the battery flap in place.

    • Add in your leaves by using glue, tape, or other means.

    • Pin it to yourself to look cool at fancy dinner parties or events.

Finish Line

Attached Documents

Joshua

Member since: 11/16/2017

48 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 7

Past 30 Days: 21

All Time: 726