Skip to main content

1.4

Major VersionM

by Pete Prodoehl

Introduction

Use our Robotics Board to control a NeoPixel with a pushbutton.

Video Overview

Featured Document

  1. Build the circuit as shown in the diagram using the components specified.
    • Build the circuit as shown in the diagram using the components specified.

  2. Install and launch the Arduino software. Click on the Sketch menu, select Include Library, and then Manage Libraries... On the top right side type NeoPixel and it will show the results in the bottom of the window. We want the Adafruit NeoPixel library by Adafruit. Click the Install button.
    • Install and launch the Arduino software.

    • Click on the Sketch menu, select Include Library, and then Manage Libraries...

    • On the top right side type NeoPixel and it will show the results in the bottom of the window. We want the Adafruit NeoPixel library by Adafruit. Click the Install button.

    • The library will be downloaded and installed, and then show the word Installed along with the version number.

    • If you are done installing libraries click the Close button in the lower right corner.

    • (These instructions can also be found in the PDF file Installing-NeoPixel-Arduino-Library.pdf)

Finish Line

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

1 Reputation

43 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 10

Past 30 Days: 14

All Time: 27