Skip to main content

1.7

Major VersionM

by Pete Prodoehl

Introduction

Use our Robotics Board to control and RGB LED with three potentiometers.

Video Overview

Featured Document

  1. Build the circuit as shown in the diagram using the components specified.
    • Build the circuit as shown in the diagram using the components specified.

    • When connecting the potentiometers, do not cross the tape coming from 5V and GND. (This would create a short circuit.)

    • You can run the GND tape between the LEGO studs (in the gutter) and the 5V tape on top of the LEGO studs so they do not overlap.

Finish Line

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

1 Reputation

43 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 20

All Time: 37