Skip to main content

2.5

Major VersionM

by Pete Prodoehl

Introduction

Use our Robotics Board to control an LED with a light dependent resistor.

Video Overview

Featured Document

  1. Build the circuit as shown in the diagram using the components specified.
    • Build the circuit as shown in the diagram using the components specified.

    • The light dependent resistor can be inserted into two of the pin sockets on the Female Header component.

    • The standard resistor can be inserted into the Screw Terminal component. (You'll need a small screwdriver to tighten the connectors.)

  2. Upload the Arduino sketch to the Robotics Board.
Finish Line

One other person completed this guide.

Attached Documents

Pete Prodoehl

Member since: 03/04/2020

131 Reputation

134 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 16

All Time: 103